Description

High-voltage device with 6 stainless steel double contact plates in a super flat design, combined with ultrasound and light-emitting diodes.

High-voltage device based on the electric fence principle, in a new slimline design and with double-pole stainless steel contact plates, combined with ultrasonic defense.

It has 2 piezo loudspeakers and no longer needs a hood contact switch, as it can be switched off directly on the device. The new sensor technology immediately detects the movement of the vehicle and switches the device off. As soon as the vehicle comes to a standstill, the device is switched on again, so there is no connection to terminal 15. The flashing control lamp shows that there is sufficient voltage and irritates the marten even more. Dust and waterproof according to IP65.

The contact plates can be placed individually, making the device universally suitable for all types of vehicles. To achieve an optimal effect, it is recommended to mount the contact plates in the upper third of the engine compartment.

The installation time for this device is reduced by approx. 50 percent!

- 12 volt connection, sensor technology
- 6 stainless steel contact plates with minus and plus pole
- Power consumption only approx. 0.4mA
- 2 ultrasonic piezo - Loudspeaker
- Effective radiation angle of more than 170 °
- Suitable for CAN data bus
- Waterproof according to IP65
- Frequency modulation
- Frequency 20 - 25 kHz
- Sound pressure at least 110 dB
- Very easy assembly (fully wired)
- e1 marking

Scope of delivery:
- Pre-assembled Device
- 6 double stainless steel contact plates
- Screws for attaching contact plates to cables
- Cable ties for installation
- Stickers (attention high voltage)
- Installation instructions